- Easy Change Chuck System
- Displays KG, PSI or BAR measurement
- Allows accurate reading of tire pressure assisting with functionality of use with TPMS (Tire Pressure Monitoring System)
- Two position lever; 1st position deflates, 2nd position inflates
- Works on a nitrogen system
The battery is extremely difficult to replace if you follow the instructions in the owner's manual.
Two screws need to be removed that you can't see and seem to have been installed with Loc-Tite or tightened by a gorilla.
One screw broke the tip off a quality screwdriver, the other screw's head stripped out.
I gave it two stars only because it was a slow day and I was able to devote a few hours to replacing the battery.
Otherwise I would have thrown the thing away and gave it one star.
I may have been tempted to buy a new gauge just like it though, it's a great gauge other than the battery.
My advice is to ignore the battery replacement instructions in the owners manual and instead remove the allan head screw (metric) in the back and push the entire gauge head out of the rubber. At least this way you can see the screws you need to remove.
Make sure to keep the owner's manual, you'll need it just to see how the gauge comes apart.
Almost two years later:
Still the best gauge I've every owned but don't make the mistake I did and use it to check calcium filled agricultural tires, it corrodes the sensor circuitry. Now I know better, will be ordering another.
Buy Astro Pneumatic 3018 3-1/2-Inch Digital Tire Inflator with Hose Now
This tire gauge/inflator is better than Blue-Point (Snap-On). It reads to 0.1-PSI and I got it calibrated to check its accuracy...this gauge is accurate to 0.01-PSI! It was not off more than 0.01-PSI. I only had it calibrated to 80.0-PSI, but will read to 175.0-PSI. This gauge is very well made and tough and it has a nice feel. At half the price of a Blue-Point, it's worth four times that. If you want a tire inflator, this is the one to get.Read Best Reviews of Astro Pneumatic 3018 3-1/2-Inch Digital Tire Inflator with Hose Here
I received my item yesterday. The unit arrived packaged great, brand new, no issues. I started to install a male fitting onto it and realized I needed to install the battery. The only issue I had was installing the battery. The directions did not state what size phillips head to use so I started with a typical #2, it ended up being to big, way too big and the screw actually ended up stripping. I know whoever will read this will probably say I should have looked at it, I did. But you cannot see what size the head is because the whole tool is wrapped in rubber for durability I guess. Just two little slots to stick the screw driver in. Anyways, take your time, and start with a smaller screw driver. I ended up replacing the screws to my size liking. Unit works great.Want Astro Pneumatic 3018 3-1/2-Inch Digital Tire Inflator with Hose Discount?
After over 25 years of looking, I finally found the air gauge/inflator system with all the features I desired but never thought I'd find in one unit. It is simply the best I've ever owned. One step, single hand operation, either adding or reducing air pressure with instant and accurate digital readout. You do not have to repeatedly remove the air hose and then measure and then again, etc., as with other systems. Plus, it seems to be of commercial/industrial grade construction -high quality fittings, hose, and protection encased readout. Absolutely 100% satisfied, highly recommended.Nice, accurate inflator. Comes with one extra battery and no matter what anyone else said the battery installation took a whole 5 minutes. I just wish the rubber protection fit a bit better, but it will do the job.
Your accuracy claims are utter nonsense. A digital gauge that reads in 0.1 increments cannot be calibrated to 0.01 when it cannot even display hundredths of a psi. The AP spec sheet claims +or- 1.2 psi to 59 psi and +or- 2 psi above that.
ReplyDeleteYour accuracy claims are utter nonsense. A digital gauge that reads in 0.1 increments cannot be calibrated to 0.01 when it cannot even display hundredths of a psi. The AP spec sheet claims +or- 1.2 psi to 59 psi and +or- 2 psi above that.
ReplyDelete