- Compact oiler that fastens directly to the air tool
- Precisely meters proper amount of oil to the tool only when the tool is in use
- Use on all air impact guns, air wrenches, body shop air tools and pneumatic hammers requiring 1/4 inch air lines
- Never use motor oil in pneumatic tool
- Prevents burn out of expensive pneumatic tools stops; rust and increases torque up to 25 percent
The oilers are trouble free, automatic and constantly protect the tool from wear and it is not necesary to remember to hand inject oil into the tools several times each day; it's done automatically. The oiler is made of clear material so that it's obvious when to add the pneumatic oil.
We've never had a pheumatic tool breakdown when the tool has always been operated with an automatic oiler. Just be certain to use pheumatic oil and not a substitute.
Buy Tru-Flate 41-101 In-Line Tool Oiler Now
Great Product.Easy installation. I would forget to oil my tools every time I used them. With this self oiler ,I just check the glass bowl to make sure it's full of oil and I'm good to go. When filling just remember to unscrew the bowl slightly so you break the air pocket.Read Best Reviews of Tru-Flate 41-101 In-Line Tool Oiler Here
I was dissapointed with this thing.Its very hard to fill it with oil without spilling it all over. I opened the jar up a bit like they say to and tried to put the oil in, but always wind up spilling.
Its way easier for me to just add a couple drops to the tool inlet at the start and end of each tool use as I connect it. Its less work than dealing with this.
It has a rather crude mechanism within it to control the dispensing of oil that relies on compressing a little o-ring with a set screw and metal disk.
Is it too much oil? Too little? Does it change over time? Do you want to trust a $400 impact to this device or know for sure its been oiled by adding a few drops
yourself?
I wish I hadnt bought it.
Thats my experience with it FWIW. I dont recommend this at all.
No comments:
Post a Comment