New Heavy Duty Pressure Switch for Air Compressor 25 amp 95-125 Single Port Connection w/ unloader &

• Brand New 25 Amp Heavy Duty pressure switch 95-125 - 1 port - unloader & on/off lever
• FREE SHIPPING
• 25 Amps at 110, 230 or 460 volt - single or three phase
• UL Approved
• Can be used with 1 - 25 amp motors without a magnetic starter

I needed to replace the Siemens switch on my Ingersoll compressor, and chose to save a few bucks. So far, I feel that this switch is worth the money, and right now it works fine. The on/off switch feels a bit flimsy, and in general the assembly seems to lack the durability that I have seen in Square D and Siemens switches. Time will tell. I'm sure that it is an adequate budget alternative for most people. If it fails, I'll spend the extra money next time, but I'm the type of guy that usually buys the high-end brands.

Buy New Heavy Duty Pressure Switch for Air Compressor 25 amp 95-125 Single Port Connection w/ unloader & Now

Only problem I have withthis switch is that it has no port for the pop off valve!!!....I had to add a "T" between the tank and switch.....Operation is dead on!!!

Read Best Reviews of New Heavy Duty Pressure Switch for Air Compressor 25 amp 95-125 Single Port Connection w/ unloader & Here

This switch is just what you need to replace the pressure switch on your old generic air compressor. because of the unloader valve built into it. Just a standard pressure switch won't do, just in case you don't realize it. Great switch, and the price is good. Mike Brainerd

Want New Heavy Duty Pressure Switch for Air Compressor 25 amp 95-125 Single Port Connection w/ unloader & Discount?

A very good value for the money. Works perfectly. My only complaint is the on/off lever looks fragile. Great delivery, good piece of equipment at a great price.

Save 43% Off

It's been a while since I bought it, the switch itself has been in service for about 2 years now. One thing that I did have to do was expose the earth ground down to bare metal as I did get lit up on my unloader valve. Keep in mind that if you're running a heavy duty compressor where your motor amps are 20+, the start amps are usually greater and the amp rating for the switch is maximum, not rms. Otherwise I've recommended this to several friends and wouldn't hesitate to purchase again.