- Power texture sprayer for walls and ceilings
- Applies popcorn, orange peel, and knockdown textures on walls and ceilings
- Powerful air turbine and 1-gallon adjustable hopper for fast coverage of large surfaces
- Includes 3 spray nozzles, 1-gallon adjustable hopper
- Weighs less than 5.7 pounds
After reading the previous reviews I was encouraged to purchase the sprayer. I played with the mixture's consistency and practiced spraying most of the morning and then tackled a small closet that included the ceiling.
It was messier than I expected with not just pieces hitting the floor but gobs oozing out of the nozzle and onto the trigger. (The instructions mention that some water may leak out of this area.) If you are an Amazon lady or trained with the military and are used to holding an AK-47 or lift weights on a daily basis you should be fine pulling and holding the trigger and holding up the sprayer to get the coverage you want. (I had to use two hands at times to keep the trigger fully pulled.) I only finished because it became personal after the first hour. I was trying to get the pattern that would match my existing texture so maybe I was expecting a little too much. (Professional texture man is scheduled to arrive in a few days.) I will still use the machine to texture the walls in the garage but I was not able to get the design I wanted for the house. I am good about reading and following directions so I do not think I could improve upon the performance except with maybe more target practice. I did find that clean-up was not bad at all.
NOTE-----Updating you on my 2 star review. The professional painter/texture man showed up and guess what he was using? Yep, the same Wagner machine! He has had it a long time and swears by it. He complimented me on my closet and said that he had to go through the same trial and error but the main tip he gave was very thin mud. I watched and it was very runny. The instructions state "like pancake batter" but his was VERY THIN. Can't stress that enough. Still was messy on application but not like when I used it and it will not work you as hard since you will not have the mixture so thick. So, based on everything he said and the fact that he no longer uses the bigger machines and his Wagner had tape all over it from obvious hard use, I am upgrading it to 4 stars and withholding the one star for when I attempt the garage. Hope this helps!
Buy Wagner Spray Tech 520000 Power Tex Texture Sprayer Now
My wife and I just purchased our first home and she really dislikes popcorn ceilings. So she insisted that we have it removed and put up a knockdown texture in it's place. Then after a few estimates, the cheapest we could get it done to our whole house was for a little under $3000 which was more that what we were willing to spend with all the other things that we needed to have done to the house. So I priced out all the materials needed and my estimate came in at about $900. Keep in mind that this price is also including the cost of the tools needed (ex. 1/2" drill, trowel, paint primer, sprayer, ect.) which I didn't own.Anyway, after going to my local Home Depot, they wanted about $60 a day to rent a sprayer and since I wanted to take my time, this really wasn't an option. I know that Wagner states that this sprayer is really for touch up jobs and not exactly for doing a whole house but let me tell you, I did my whole house and it worked great. After practicing a bit in the rooms first, my results were identical to a professional job at 1/3 the price. I will tell you this, it is a lot of work and the hardest thing about it is removing the popcorn and preping the room. I know some people say to use a garden sprayer and then they sell this neat little scraper at Home Depot that you can attach a bag to so you don't make a mess but that scrapper is junk. If you want to move fast, tape up the walls and floor using plastic sheeting and use a garden hose with a 10 or 12 inch taping knife to remove the popcorn. You'll barely scratch the sheet rock underneath and you'll remove the popcorn in under 30 minutes per room. The whole process is truly a huge mess but the end result is a very nice looking textured wall. I decided to go with the medium nozzle (yellow) and I ended up with a very nice looking texture that isn't as bold and some of the houses I've seen.
So if you're in the same situation my wife and me were in and you're fairly competent with tools, you'll be able to do the same thing because I'm a complete novice when it comes to drywall textures and I ended up with a great looking house. I'll also be honest and tell you that the first room I did, didn't come out as nice as the last but not because I applied the texture incorrectly but because I knocked some of it down too soon. Make sure you wait at least 20 minutes before knocking it down and after you spray a wall, take a step back and if you see any bare placed, just go over it with a quick trigger pull and you'll be amazed at what you're left with.
Read Best Reviews of Wagner Spray Tech 520000 Power Tex Texture Sprayer Here
I am rehabing a home in Tampa, florida, and tried with mixed results to use the spray texture cans from Home Depot . six cans with six different poor results. I purchased this sprayer, shot an entire bathroom with AWSOME results. I LOVE IT. Buy oneWant Wagner Spray Tech 520000 Power Tex Texture Sprayer Discount?
I was a little sceptical about this product doing as it says, but after finishing my living room all doubts where erased. Now wait, it does have a learning curve, don't think taking it out of the box and start spraying away will yield great results. Not likely. If you pratice like others have said that helps greatly. I think the hardest part was getting the drywall mud to the right consistinsy. I did orange peel, believe when I say if you think it has enough water in it add a little more. When I took the mixing paddle out, the mud came right off, did not stick, runny, soupy like, allot thinner than pancake batter. Do a pratice spray on cardboard and check your results. Do a back and forth motion about 2 to three feet away and do not stay in one place to long. Go over again for heavier texture. Not too much on first passes though or it will not look too good. Let it dry then go over it again. Few other things is I did a large room 15 by 20 by 16 ft high. It makes it harder,but not impossible. If you do a large area everytime you refill take off the nozzle clean it and the opening on the gun. If not it will clog up and flow will stop or the mud in the hopper will bubble and blow up out of the hopper, not that dramatic but you will hear it bubbling and rumbling you will know, then you have to clean it. Only takes min or two. Cover your mixed mud while spraying or it will harden. Also I noticed it did firm up a bit in the bucket even though it was covered, so adding a little water would not hurt each time. Just depends on your mud. IT IS ALSO VERY VERY MESSY....Cover EVERYTHING, windows, floors, vents, dogs, cats...Really you will regret it if you don't. It not for pin point accuracy, comes out fowards but in a wide arc, shallow arc, whatever it feels like. You do have some control, dont get me wrong, but there is some leakage, and if you dont cover the floors they will be textured as well. Its fun, also the unit loaded with mud is heavy, and large projects can get tiring. Oh also I placed it on the ground to load it, hopper in the position to do walls, easy. Also something to keep in mind, I primed my walls and ceiling it made it difficult to see results and where I sprayed, I had to bring in utility lights, still was hard, I suggest using a tinted primer close to what you will eventualy paint the walls, if white oh well, but I know if you can, it will be easier to see what you doing and get faster results, thats the only headache I had white mud white walls blends in...ahhh.. Not Wagners fault though. I highly recommend it, just be prepared and be patient and I believe you will have fun too and yield great results...Everything is easy to clean too..Have Fun..Im a professional drywall finisher of over 10 years, and think this thing is great. No more hauling in a heavy texture rig and dirty hose for patch jobs. For the do-it-yourselfer $100 it isn't much more than a regular hopper and gun that requires a compressor. Great price for a sweet sprayer.
No comments:
Post a Comment