This was one of the cheaper blast cabinets I have found that requires a lower CFM output from your compressor. The setup instructions were almost non existant, a few pictures and some vague instruction on how to assemble the unit. I mostly had to figure it out myself. The blast gun leaks air right from the start which means my compressor is running non stop while I'm using the blast cabinet. The media settles everywhere except over top of the pickup tube opening so I'm constantly having to stop and shake the media around to get it over the syphon tube opening. It also leaks media out of some of the seams. I think I'll have to caulk the seams or something like that. Now having said all that, it does work. I have run several pieces from an old lawn tractor that I'm trying to restore through the cabinet and it takes the paint and rust off which is all I need it to do. So in that respect I have to say, it works, but it's certainly not the best unit in the world. If you're looking for a low cost cabinet that will get the job done, but just barely, then this is for you.
No comments:
Post a Comment